Rear End Removal Dec 11, 2011

 

 

Finally got the upper nut cut off.  I started from under the car and then went in through the top of the trunk.  Took a lot of prying to get this far – can’t figure out why the bottom bracket stayed on the bolt!

Finally got it removed from the rear frame rail:

Created a small mess that needs to be cleaned up!  Now you can see part of the reason I went in through the top:

Here is the view from the top of the trunk:

Used the Plasma cutter to prep the driver’s side for cutting (luckily the trunk will be removed for new metal later so I can remove what was in the way!) – before and after:

 

Leave a Reply

Your email address will not be published. Required fields are marked *

Time limit is exhausted. Please reload the CAPTCHA.