Done with the cutting unless I screw something up and need to re-cut something!  Next I can focus on drilling some holes with the new drill press!

Got some 6″ 2.5×2.5’s:

and a few 2×2’s, angle irons, plates, and misc pieces – I will post the guage and lengths as I start welding as a picture is worth a 1000 words (or so I hear!):

A few extra pieces:

About 150 Zinc plated nuts and bolts to use as set screws:

Also have a mess to clean up from all of my cutting – that dust went everywhere!  If I had it to do over again, I would use a band saw!:

Got the 2×2 plywood base on my drill press…  Need to go to Menards and get some cutting oil so I can start drilling!