Finished the major cleaning on the floor this weekend and started to look at what needs to be done on the wheel wells.  I spent some time on the lower inside quarter panel only to determine it was mostly undercoating which I will tackle this week.

Decided to begin with the Dremel Multi-Max.  I switched from the rigid to flexible scrapers – starting with the flexible and moving to the rigid where needed.

A before shot of a section of the drivers side wheel well:

After experimenting with the Dremel:

After shot of the other side:

This next weeks focus will be the wheel wells and inside lower quarters.  Then on to the wax and grease remover before finally stripping.