So I was referencing the measurements of my manual 4-speed shifter hump I installed from here and realized I was off by about an inch and need to re-do my work. Today was spent analyzing, measuring and planning next steps. This is the piece that the shifter sticks through that I need to redo:
I re-attached the bracing and used an older console to cross-reference since I am wanting it to be as close to the stock location as possible and will be using a similar console:
I am actually impressed that I got it this close on my first try, but referencing the picture and measurements in the above link, I need to adjust the location which will mean cutting it out, patching part of the hole, and re-attaching a new shifter-hump.
I have accumulated some donor parts. Not the top piece in brown is the original section I cut out the first time (on the blue piece):
Unfortunately, the brace is closer than I would like – this piece looks to be from a firebird, but close enough… (on a Camaro, the brace is further back by comparing to my patch panel)
After some thinking and experimenting and a failed attempt to remove the brace, I ended up cutting it as close to the brace as possible:
Using my other donor piece as a mold, the larger piece I will be working with appears to be flexible enough that I might be able to use it as a patch piece with a little persuasion…
More to come… Stay tuned for more…