Also worked on the inside quarters in the trunk – there was some undercoating in spots I needed to remove.
After Dremel:
Before:
Then used some paint thinner for the remaining gunk:
2 thoughts on “4-09-2017 – Inner quarters \ trunk”
Hello Doug, will you be doing any of your drop offs in your car? I was wondering because I’m going to need to replace one of my drop offs and I was wondering what your plan of attack is?
No… This is an Arizona car. The only sheet metal I needed to patch was the drivers toe-board. My goal this summer is to undercoat the bottom and trunk, so was doing some initial prep-work with the cleaning. I have gone over the rest of the car and don’t see any other spots that need to be patched. There are a couple of small areas, but nothing too bad. Might want to ask in the Body section on NastyZ28.com – I am sure you will get plenty of opinions.
Hello Doug, will you be doing any of your drop offs in your car? I was wondering because I’m going to need to replace one of my drop offs and I was wondering what your plan of attack is?
No… This is an Arizona car. The only sheet metal I needed to patch was the drivers toe-board. My goal this summer is to undercoat the bottom and trunk, so was doing some initial prep-work with the cleaning. I have gone over the rest of the car and don’t see any other spots that need to be patched. There are a couple of small areas, but nothing too bad. Might want to ask in the Body section on NastyZ28.com – I am sure you will get plenty of opinions.