3-4-2018 – S-10 Door

Didn’t get as much done as I had hoped.  I did get the door off.  Ended up using a hammer and punch to get the pins out.  Needed to jack the end of the door for the bottom pin (first), then the center or entire door for the upper pin (last) after first removing the spring.  Not too bad once you know what to do.  Next will be to mount the replacement door this next week then swapping components from one to the other.  Having a door jack is needed for a one man operation!  Luckily, I don’t need to drive anywhere this next week!

Leave a Reply

Your email address will not be published. Required fields are marked *

Time limit is exhausted. Please reload the CAPTCHA.