![\"\"](\"https:\/\/dougbratton.info\/blog\/wp-content\/uploads\/2012\/11\/P10100022.jpg\" "\\"P10100022\\"")
<\/a><\/p>\nOther side:<\/p>\n Cleaned-up the edges a bit and decided on focusing on the passenger side first where the rusted-out area was bent up from removing the firewall bracket:<\/p>\n So I used the plasma cutter to trim some of it away so the pan will sit in there better to give me an idea of where to cut next:<\/p>\n The plan for tomorrow is to cut the floor area smaller than the patch panel, then – if time permits, trim the patch panel to fit in the cut-out area. \u00a0I should also mention that there are two ways to do this: either lap one piece over the other (easier) or butt them right next to each-other side-by-side (harder). \u00a0I want to butt them together which is a little more work and difficult, but should have better results in the long run.<\/p>\n","protected":false},"excerpt":{"rendered":" Had a little bit of time today so played with the patch pieces because before I can replace the firewall brackets, I need to patch the toe-board areas. \u00a0I must also take into consideration where my patch will connect with the full floor pan I will be replacing. \u00a0So after studying some pictures of a … Continue reading Toe Boards Nov 17, 2012<\/span> <\/a><\/p>\n<\/a><\/p>\n<\/a><\/p>\n<\/a><\/p>\n<\/a><\/p>\n<\/a><\/p>\n