Finally got the car primed in Epoxy primer. 2 coats inside, 3 outside. Click the image to cycle through the pictures. I was worried with the primer when I saw that some had leaked out and gelled. All turned out just fine.
Daily Archives: October 12, 2015
Dash Bezel
I also worked on the bezel. Got a New Old Stock washer switch unique to this bezel (1973) and installed it along with the light switch.
To get the light switch removed and installed, there is a screw you need to press and then remove the handle.
Picklex – applied
After applying the picklex and allowing it to dry, there was some chalky residue left over in spots. I gently scuffed it away after asking the vendor, then tacked it off to be ready to prime. (Click image for slideshow).
POR-Patch
It has been a while since I last updated my progress. Will make several updates today. First, I used por-patch on both sides of my patch panel (click image to cycle through the pictures). This comes in a tube and I ran a bead along the welded area, then used an acid brush to smooth it out. This sealed and pin holes that might be left over from welding.
