Got the other fender sanded tonight… This was the new one from AMD – the black EDP coating was much easier to remove.
Category Archives: Camaro
Aug 11, 2014 Update – Priming
Worked on stripping the drivers side fender… Still have a little to do on the edges.
Aug 10, 2014 Update – Priming
Finally started priming today. All dressed up…
3 coats of primer on the trunk lid…
Ready to primer the rest of the parts and car now…
Aug 7, 2014 Update – Priming
A little sanding to catch the flash-rust to prepare for priming this weekend… Taking tomorrow (Fri) off from garage work…
Aug 6, 2014 Update – Priming
More sanding tonight – lower nose before…
Lower nose after…
Aug 5, 2014 Update – Priming
Back at it tonight… Got the upper front nose panel sanded and ready to prime.
Jul 25, 2014 Update – Patch
I read about using POR Patch as a sealer over welds. I am going to use this on the floor board patch. I discovered that it is out of stock on-line, but there is a authorized reseller in Red Wing an hour away. They only had one, so I went and bought it…
Jul 24, 2014 Update – Priming
Got my plastic hung up around the trunk lid after moving the Camaro forward (on Rotisserie)… This is before the surrounding piece to enclose it…
Trunk lid hung from ceiling so I can prime both sides at the same time.
During final check, had to figure out the new regulator since there was no air going through the new hose… Finally got that figured out…
Then there were leaks through the hose reel air hose connectors… Off to Northern Tool for some replacements… Then broke a piece on the hose reel and then off to Harbor Freight for replacement…
Not enough time to start spraying, but everything is all ready to give it a go tomorrow… Glad I didn’t wait to the last minute to start on this!
Jul 11, 2014 Update – Priming
Other half of roof and passenger side quarter panel are now complete. My arms are like Jelly! One more day of sanding tomorrow… Notice the mess on the floor that will have to be cleaned-up!
Jul 10, 2014 Update – Priming
Relocated my hose & reel for the new piping setup and so I could run my air tools today.
A lot less water in my lines with the new setup… Got a quarter panel stripped and half of the roof sanded to bare metal. Took me most of the day to do. I took today and tomorrow off to work on the car.
