Spent most of my project time digging out my tire dollies to use with the subframe to roll it under the body. I had 2, but had to hunt and then dig out the other 2. Now I am thinking I only need 3 of them because of lack of width space between the jacks the are holding the shell of the body.I am going to use 2 in front and then one in the middle with a board to support the back end.
I have cut the board to match the width of the subframe. Of course the yellow stuff is foam to protect the subframe from where it sits on the dollies. Hope to find more time tomorrow to transfer the subframe from the jack stands to the dollies and see if it will work the way I want and fit under the body. I am sure I will be removing the subframe at a later point when I change out the bushings again, but shouldn’t need to roll it out from under the shell again.