Three coats of primer on the fenders… Will still need to do body work, but trying to get as much primed before it gets too cold.
Aug 16, 2014 Update – Priming
Got the front nose pieces covered in 3 coats of primer…
Had to get a 3M paint preparation system (PPS) so I could paint at all angles including upside down…
Aug 14, 2014 Update – Priming
After taking last night off, wrapped up the edges of the fenders and did the outside of one door (still need to do edges)…
Aug 12, 2014 Update – Priming
Got the other fender sanded tonight… This was the new one from AMD – the black EDP coating was much easier to remove.
Aug 11, 2014 Update – Priming
Worked on stripping the drivers side fender… Still have a little to do on the edges.
Aug 10, 2014 Update – Priming
Finally started priming today. All dressed up…
3 coats of primer on the trunk lid…
Ready to primer the rest of the parts and car now…
Aug 7, 2014 Update – Priming
A little sanding to catch the flash-rust to prepare for priming this weekend… Taking tomorrow (Fri) off from garage work…
Aug 6, 2014 Update – Priming
More sanding tonight – lower nose before…
Lower nose after…
Aug 5, 2014 Update – Priming
Back at it tonight… Got the upper front nose panel sanded and ready to prime.
Jul 25, 2014 Update – Patch
I read about using POR Patch as a sealer over welds. I am going to use this on the floor board patch. I discovered that it is out of stock on-line, but there is a authorized reseller in Red Wing an hour away. They only had one, so I went and bought it…
